扫码咨询

新闻动态

首页 >> 新闻动态 >> Huashi HSPA0218-43A Solid-State Power Amplifier: 20 W CW across 2-18 GHz with Full Status Reporting
详细内容

Huashi HSPA0218-43A Solid-State Power Amplifier: 20 W CW across 2-18 GHz with Full Status Reporting

The HSPA0218-43A broadband microwave solid-state power amplifier, developed, manufactured and sold by Shenzhen Huashi Digital Technology Co., Ltd., delivers saturated output power above 20 W across 2-18 GHz. It provides power, temperature and current reporting, over/under-voltage alarm, and over-temperature, over-current and over/under-voltage protection, and is widely used in microwave test equipment, communication, radar and EMC/EMI test systems.

HSPA0218-43A amplifier module

Figure: HSPA0218-43A solid-state power amplifier module

HSPA0218-43A harmonic suppression

Figure: Measured harmonic suppression of the HSPA0218-43A

1. Product Features

  • Saturated output 43-45 dBm across 2-18 GHz (CW at room temperature);
  • Small-signal gain 51-58 dB, power gain 43 dB min;
  • J30J-15ZKP low-frequency connector with analog reporting and high/low-level alarms;
  • Pulse modulation supported, minimum period 1 μs, on/off delay approximately 250 ns / 400 ns.

2. Key Specifications

ItemSpecification
Operating frequency2-18 GHz
Saturated output power43 dBm min (Pin=0 dBm, CW)
Power gain43 dB min
Small-signal gain51-58 dB (Pin=-30 dBm)
Input VSWR2:1 max
2nd harmonic suppression10 dBc min
Spurious suppression-60 dBc max
DC power consumption170 W max
Supply voltage26-30 V DC (nominal +28 V)
Quiescent current2.4 A @ +28 V
Full-power current5.5 A average, 6.2 A max (auto shut-down above 7.5 A)
Operating temperature-40°C to +65°C (-40°C to +85°C near the housing)

3. Operating Notes

The module must be mounted on forced-air or liquid cooling. Power-on sequence: cooling, supply, enable, RF input; power-off in reverse order. Recommended RF input is 0 dBm and must not exceed 10 dBm. The output must see a load rated 50 W or more with VSWR better than 5:1; insert a 40 dB / 50 W attenuator before connecting instruments. CW operation dissipates about 140 W of heat, so cooling must be ensured.

4. Supply and Customization

The HSPA0218-43A is in volume production with a user manual supplied. Huashi provides in-house R&D, manufacturing and sales of solid-state amplifiers and customizes output power, bands and reporting interfaces.

For selection support and quotation, please contact Huashi Sales: 18688706870. Website: www.szwisi.com.

客服中心
联系方式
18688706870
0755-29210759
- 销售
微信18688706870
seo seo